Product Description
The AutoFinish™ DCPC250 is a high-energy centrifugal barrel finishing machine for low- to mid-volume dental laboratories. It uses media, soap and centrifugal force to smooth, buff and polish prosthetics, automating hand finishing and polishing.
Validated workflows include removable (conventional, milled and 3D-printed dentures, partial frameworks, flexible partials, splints and nightguards), implant (All-on-X hybrids and dentures on implants - conventional, milled or 3D-printed) and crown & bridge (zirconia and full-cast gold, noble and non-precious).
- Total capacity: 0.25 cu ft (7.07 L)
- Barrels: 4 per machine; each 0.0625 cu ft (1.77 L), W 4.5" x H 6"
- Turret speed: 0-350 RPM, fully adjustable
- Drive: 1 HP, inverter-controlled, single-phase
- Controls: Touchscreen with process (recipe) storage and countdown timer
- Noise: under 70 dB
- Construction: 304 stainless steel machine; coated steel barrels with urethane liners
- Power: 208-240 VAC (+/-10%), 50/60 Hz, single-phase, 16 A; a 240 VAC / 20 A NEMA receptacle or 2-pole 20 A breaker, checked by a certified electrician
- Compressed air: not required
- Dimensions: W 28.5" x D 30.1" x H 51.5"
- Weight: approx. 480 lb
- Warranty: up to 3 years, determined by component
- Shipping: Ships in a 43" x 43" x 64" crate, with supplies and consumables in the crate. Freight quote required.
Site requirements: a level floor with 6" clearance on every side (the machine stands on the included isolation pads and must not be fastened down), and ideally a sink with a plaster trap nearby.
